Brand: 8milelake

Product Code: SZ6411

Availability:In stock

$49.99 49.99
  • Drift sizes - (55.5, 59, 62, 65, 66, 71.5, 73, 78, 84, 86, 91mm)
  • Hub Screws: 3PC M12 x 1.5mm , 3PC M14 x 1.5mm
  • Suitable for most front wheel drive cars, light trucks and vans
  • Comprehensive set for the removal and installation of front hub bearings
  • Blow mold case for storage
  •  

    Operation:

    Step.1 Determine if the vehicle has a trapped rotor or a floating rotor.

    Step.2 Assemble the tool components, and press out the worn bearing.

    Step.3 Lightly lubricate the new bearing, and position it for installation with the tool

    components assembled. Press the bearing into the spindle assembly until it bottoms.

    Step.4 Fasten the bearing retainer in place using the bearing retainer bolts. (On Neon vehicles, install the snap ring in the knuckle.)

    Step.5 Assemble tool components. Lightly oil the hub assembly, and install the hub. Attention​: The bearing installer must be assembled with the flat side toward the bearing and the small diameter pilot on the side away from the bearing.

    Step.6 Assemble the remaining vehicle components that were removed for bearing replacement: (1)lower ball joint to steering knuckle assembly brake rotor. (2)disc brake caliper. (3)outer tie rod nut and tie rod. (4)axle nut. (5)front tires.